![]() My DD-WRT does not support JFFS2, or there is not enough space in my JFFS2 partition, how can I install Wiwiz HotSpot Builder Utility then? Please use the right version of DD-WRT that supports JFFS2, enable it, and make sure there is plenty of space on JFFS2 partition.ĩ. It seems that the DD-WRT you are using does not support JFFS2, no enough space on JFFS2 partition, or JFFS2 support is not enabled. sh: /jffs/usr/local/hsbuilder/hsbuilder_setup4dd-wrt.sh: not found When I run “/jffs/usr/local/hsbuilder/hsbuilder_setup4dd-wrt.sh -dest /jffs setup”, the following error shows: I am trying to install Wiwiz HotSpot Builder Utility in a DD-WRT router/wireless router. Please make sure your router/wireless router connected to the Internet, and try it again.Ĩ. It seems that you did not connect your router/wireless router connected to the Internet, or downloading temporarily failed. Tar: can’t open ‘/tmp/root/’: No such file or directory When I run “cd /jffs tar -zxf /tmp/root/”, the following error shows: usr/local/hsbuilder/hsbuilder_setup.sh uninstallħ. jffs/usr/local/hsbuilder/hsbuilder_setup4dd-wrt.sh -dest /jffs uninstall How to uninstall Wiwiz HotSpot Builder Utility? usr/local/hsbuilder/hsbuilder_setup.sh disableĦ. If you installed it on a Linux computer or in a virtual machine, you can run this command : # /jffs/usr/local/hsbuilder/hsbuilder_setup4dd-wrt.sh disable If you installed it in your DD-WRT router/wireless router, you can run this command : How to disable Wiwiz HotSpot Builder Utility? ![]() Please be sure you are using the official version of VMWare. Please reinstall Wiwiz HotSpot Builder Utility,and use a third-party DNS address when specifying DNS, such as Google’s 8.8.8.8 or DNS server provided by your ISP. It may be caused by DNS resolving failure due to firewall or other networking problems. Network settings in virtual machine is not properly set, NAT service on host machine is unavailable, NAT networking failure caused by wrong firewall settings. Your host machine is connected to your router wirelessly, but not with a cable. I installed Wiwiz HotSpot Builder Utility with VMWare,and my WiFi client connected to the hotspot successfully, but I cannot open any web page. And you should configure and startup the DHCP service on your Linux computer.Ĥ. If you are using a wireless router as AP, you should disable the DHCP and UPNP service on your wireless router. I installed Wiwiz HotSpot Builder Utility on a Linux computer, and my WiFi client connected to the hotspot successfully, but I cannot see authentication page when opening web browser. Otherwise, the authentication page of the default sample hotspot but not yours will be displayed.ģ. Please input right Hotspot ID and User Name when setting up Wiwiz HotSpot Builder Utility. I installed Wiwiz HotSpot Builder Utility, but the authentication page is not the one I set in Wiwiz Web Panel. Your DD-WRT version may have bugs, you are using a incompatible device, some kernel modules are not loaded, or insufficient memory.Ģ. Your DD-WRT device is connected to the Internet, but not with WAN port.ģ. Your DD-WRT version does not support Wifidog.Ģ. I installed Wiwiz HotSpot Builder Utility into my DD-WRT device, but I cannot see the authentication page of my hotspot when opening web browser.ġ.
0 Comments
Leave a Reply. |